Sika MonoTop®-610 T

6 months from date of production if stored in undamaged and unopened, original sealed packaging.

Store in dry and cool conditions, protected from direct sunlight.

1.15 kg/ l (dry powder)
2.00 kg/ l (freshly mixed mortar)

> 50.0 N/mm²  (28 days at 25°C)

>2.00 N/mm² (on prepared concrete)

4.2 to 4.4 litres per 20 kg bag.
Ratio Water : Powder
1 : 4.6 by weight
1 : 4.0 by volume

If a mix has thickened due to delayed application, do not dilute further with water.

Min.  1 mm
Max. 3 mm

Optimal range : between 5°C and 35°C

approx 20 minutes. (at 30°C)

For 1 litre of Fresh Mortar approx. 1.65 kg of powder are needed.
As bonding slurry :
Depending on substrate condition, approx.1.5-2.0 kg/m² dry mortar
As anticorrosion coating on reinforcement :
approx. 3.5 kg/m² dry mortar (powder) for 2 coats at 1 mm dry film thickness each.

Sika MonoTop®-610 T can be hand-mixed in small amounts for immediate application.
This is to ensure "wet on wet" application of subsequent patch repair mortars (either Sika® MonoTop®-614T or 615HB) and thus minimising wastage.
Fill sufficient clean water into a small clean container. Add Sika MonoTop®-610 T to the water and hand mix thoroughly with a spatula until you obtain a thick "slurry" consistency. Always ensure that there are no lumps in the mix.

As reinforcement protection :
Apply first layer of approx. 1 mm thickness, using medium hard brush, roller or spray to the cleaned reinforcement. Apply the second layer of identical thickness after a waiting time of 1.5 - 2.0 hrs. (at +30°C). Following repair mortars can be applied after a similar waiting time.

As bonding bridge :
Apply by brush, roller or suitable spraying equipment to the prepared (wetted to saturated surface dry) substrate. To achieve a good bond with the substrate, and to make sure that the whole area is fully coated with the bonding slurry it has to be rubbed well into the substrate.Following repair mortars have to be applied to the wet bonding slurry.