Sikafloor®-91

Epoxy

12 months from date of production if stored properly in original unopened packing.

Note:
Component (A), Sikafloor®-91, must be thoroughly stirred with a mechanical stirrer prior to each batching.
Segregation may occur after 10 hours.

Store in dry condition at temperature between +5°C and +30°C

2.1 - 2.2 kg /litre for finished screed

> 90 N/mm²

> 2 N/mm² (Concrete Failure)

Parts by Weight

Minimum substrate temperature: + 8°C
Maximum substrate temperature: + 30°C
Substrate temperature must be 3°C above measured dew-point

< 4%

These figures are theoretical and do not include for any additional material required due to surface porosity, surface profile, variations in level and wastage etc.

Stir Component (A) thoroughly with an electric stirrer prior to batching. Add Component (B) in the correct mix ratio and mix for 2-3 minutes at a low speed. Place the correctly batched quantity of Component (C) in the mixer (forced action type). Add the prepared resin mix (Components A+B) while the mixer is running, and continue to mix until a homogeneous and uniformly moist mix is obtained.

Place the mortar while the primer coat is still tacky, and rake out evenly. Level with a beam laid across steel screeding rails and finish with a steel float.

• Clean all tools and equipment immediately after use with Colma Cleaner.
• Once hardened, the material can only be removed mechanically.
• Wash soiled hands and skin thoroughly in hot soapy water.